Cell Best Height problem with Print Preview

DickBryant · Post by **DickBryant** » Wed Sep 06, 2006 7:10 pm

Hi Sergey,

I've set the RichViewPixelsPerInch := 96 as you suggested. But when I set a cell's Best Height = 96*Page Height In Inches it appears to be about 30% larger than this in the Print preview screen. So if, for instance, I use VAlign = center the text appears to be significantly below the center rather than centered.

Do I need to set something else so that the height of the cell in printpreview will be accurate?

Dick

Post by **Sergey Tkachenko** » Wed Sep 06, 2006 7:57 pm

Sorry, I am not completely understand you.
Can you send me a simple project reproducing the problem?

DickBryant · Post by **DickBryant** » Wed Sep 06, 2006 9:47 pm

I have sent a .zip of a small project that demonstrates the problem to your e-mail address svt@trichview.com

Thanks

DickBryant · Post by **DickBryant** » Wed Sep 06, 2006 11:13 pm

Here's a screenshot from the actual application. The single cell was sized as PageWidth (8.5")*96 for BestHeight. The text was then centered in the table. As you can see, the PrintPreview shows the text well below center. The printed version matches the print preview.[/img]

Post by **Sergey Tkachenko** » Thu Sep 07, 2006 7:48 pm

It's because there are areas at the top and bottom of page where printers cannot print, they are not shown on the preview, explanations by e-mail.