Document View in Editor

metalmickey · Post by **metalmickey** » Tue Apr 18, 2006 8:53 am

Hi

I've been playing with the ActionsTest demo and I note that if I start a new document, the display and the print preview are not the same (the editor is far wider then the printed page and so word wraps and new pages are in different locations). Is there some way to set the editor to display in document view (that's what Word calls it) so that the editor and the preview match?

Thanks

Chris

Post by **Sergey Tkachenko** » Tue Apr 18, 2006 10:25 am

No, it's not possible (it's possible to set document width according to the paper width, but results will be only approximate)

metalmickey · Post by **metalmickey** » Tue Apr 18, 2006 1:46 pm

Sergey Tkachenko wrote:No, it's not possible (it's possible to set document width according to the paper width, but results will be only approximate)

Hi

Thanks for quick reply, how would I do this, I've used the page setup and also moved the rulers, which makes the editor version better, but then the print preview becomes really odd.

Cheers

Chris

Post by **Sergey Tkachenko** » Thu Apr 20, 2006 7:35 pm

http://www.trichview.com/support/trichv ... size_2.htm

metalmickey · Post by **metalmickey** » Thu Apr 20, 2006 7:47 pm

Looks good, I'll give it a try. Thanks again